Multi tool slider

Project Summary

A simple 3D printable sliding system to make straight cuts or carvings with a multi tool.

Project Details


-All tolerances are tight and are intended to be tight, adjustments should be made using sandpaper. Holes may need to be drilled out

-The main rail pipes is 20 mm pipes.


Print all components, and start by assembling the sled.

When the sled is fully assembled; install it on the rails. Rail dimensions may be longer or shorter depending on the end user

.A final advise is to add a dash of hot glue to the nuts under each foot to give the slider assembly more friction during use and avoid scratching the surface it is standing on.

Average (0 Votes)

Related Assets
Remote Assets